USER'S MANUAL, VERSION 2.0
Copyright © Convergence Systems Limited 2021, All Rights Reserved
21
4.7
How to Connect to and Control CSL Intelligent
Fixed Reader
One can connect to CSL Intelligent Fixed reader via Ethernet, RS232, Wi Fi, USB and GPIO
interface, depending on which particular model.
One can control CSL Intelligent Fixed Reader in the following 7 ways:
1)
Use the browser interface and the built-in event engine to configure CS463 to run
autonomously based on certain logic sequence.
2)
Use LLRP V1.1 API to control the reader.
3)
Use CSL Unified API to control the reader
4)
Use CS461 Low Level API (MACH 1 API) to control the reader
5)
Use CS461 High Level API (HTTP/XML API) to control the reader
6)
Use CS108 Bluetooth API to control the reader
7)
Write embedded program in the Linux OS inside directly to control the reader.
To switch among 1) to 7), just go to the browser interface, System/Access Mode page, and then
choose the Access Mode, as shown below: