Operation
VA 525 EN V1.01
page
19
o
41
10.3.1.2 Input / change consumption counter
Setup
Sensor Setup
Total Counter
Unit button
Important!
When the counter reach 100000000 m³ the counter will be reset to zero.
10.3.1.3 Definition of the units for flow, velocity, temperature and pressure
Setup
Sensor Setup
Units
In order to change, e.g. the unit, first select by
pressing key
„
“
the button
“Unit”
and then
key “
OK”
.
Select with the key
„
“
the correct unit and
then confirm selection by pressing 2x
„OK“
.
Entering / changing the consumption counter
via button
„
“
, select the respective position
and activate the position with the
"OK"
button.
By pressing
„
“
the position value is
incremented by 1.
Complete with
"OK"
and
activate next number position.
Confirm entry by pressing
„OK“.
Unit selection:
according to chapter 10.3.1.3
Direct selection of the unit button and
call of the unit page with
„OK“
.
To make changes to the unit for the respective measurement
value, first select by pressing
„
“
the field of the „measurement
value“ and activate „it with
„OK“
.
Selection of the new unit with
„
“
In case the quantity of units selectable are not presentable on
one page, pleas move to next page by pressing
„<<“
.
Confirm selection by pressing 2x
„OK“
.
Procedure for all 4 measurement variables is analogous.