Crystal Vision
Operating the Active Panel
Device
Address
in frame
Notes
Modules
1.01 to 1.12
Press ENTER for module Home menu
Frame
Monitor
1.13
Press ENTER for frame s/n and temp
PSU Monitor
1.14 & 1.15
Press ENTER for PSU s/n and type
The Frame Monitor ‘module’ will display the air temperature, in degrees Celsius, inside the
frame above slot 5 where the temperature sensor is located.
Node numbers
Whilst most Crystal Vision cards have their unique card location address assigned
automatically, older cards and frames use a ‘node’ switch on each card.
In all of the current frames, this node switch should be set to zero (factory default).
For compatibility reasons, the Home menu for each module may display the module's node
number (one less than its location or slot number).
Further details of control panel operation can be found in the Indigo Control Panel User
Manual and details of module operation can be found in the documentation supplied
with each module.
Indigo 2AE and 2SE User Manual R1.17
55
27 February 2020
