Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, C
A
91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.041819
SWRFD-60E
Radio Replacement with Steering Wheel Control Retention
for Select Ford Vehicles with 4” Screen
1 of 5
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
- Retains factory features in select Ford vehicles with 4” screen.
- Pre-programmed to retain factory Steering Wheel Controls.
- Retains factory 4” screen.
- Works on vehicles with or without Sync.
- Retains factory Aux-Input on vehicles without Sync.
- Retains voice command features on vehicles with Sync.
- Phone pick up and hang up functions using the steering wheel control buttons.
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
CAN Module
SWC Module
SWRFD-60E Harness
SWC Cable
SWC 3.5MM PLUG ADAPTER
AFTERMARKET
RADIO
+12V Constant Yellow
+12V ACC Red
12V Ground Black
Illumination Orange
Reverse Gear Purple/White
Power Antenna Blue/White
Vehicle Speed Sense Pink
Right Front (+) Gray
Right Front (-) Gray/Black
Left Front (+) White
Left Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Left Rear (+) Green
Left Rear (-) Green/Black
Factory Aux Input*
24-Pin
Plug
TO FACTORY
RADIO
HARNESS
12-Pin
Connector
SWC
MODULE
ON R
ADIO
VEHICLE
1 2 3 4 5 6 7 8
AFTERMARKET
RADIO SELECTOR
(See Chart)
FORD
SWC SETTING
(OFF OFF OFF OFF)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
Cap or insulate if
not being used
Kenwood/JVC (BLUE / YELLOW)
Insulate with tape
if not being used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
LIN BUS (Green)
12-Pin
Connector
TO FACTORY
SCREEN
TO FACTORY
SCREEN
HARNESS
SWC 1
with Sync
(Orange wire)
SWC 2
without Sync
(Blue wire)
* Retention of factory AUX Input is available ONLY on vehicles WITHOUT Sync.
CAN
MODULE
