background image

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA  91311

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.110419

1 of 4

RADIO REPLACEMENT

SWC RETENTION

+

R

INTERFACING SOLUTIONS

-  

Retains factory features in select GM LAN V2 (LIN) Bus vehicles while functioning with an aftermarket radio.

-  Retains OnStar functionality.

-  Retains all chime functions.

-  Retains OEM Auxiliary Input.

-  Retains Factory Bluetooth in Vehicles 2008-upwards if equipped with the new OnStar device.

-  Retains factory Steering Wheel Controls via built-in, preprogrammed interface.

-  Retains RAP (Retained Accessory Power).

-  Includes factory backup camera connection for the IO3 system. (vehicles with IO4, IO5 & IO6 systems can be hard 

wired to retain the OEM camera. See page 3)

PRODUCT FEATURES:

PARTS INCLUDED:

INSTALLATION DIAGRAM:

SOOGM-19L MODULE

SOOGM-19L HARNESS

SWC CABLE

ANTENNA ADAPTER

SOOGM-19L

OnStar Radio Replacement Interface with Steering Wheel 

Control Retention for GM LAN v2 (LIN) Bus Vehicles 2014 - 2018

AFTERMARKET

RADIO

Reverse           Red/White

Illumina�on (+)                  Orange

+12V Constant                    Yellow

+12V ACC                         Red

Ground                       Black

Entertainment Turn On           Blue/White

Parking Brake         Yellow/Black

Vehicle Speed Sense       Purple/White

Right Front (+)                        Gray

Right Front (-)            Gray/Black

Le� Front (+)                     White

Le� Front (-)         White/Black

Right Rear (+)                     Violet

Right Rear (-)         Violet/Black

Le� Rear (+)                    Green

Le� Rear (-)        Green/Black

TO FACTORY

HARNESS

16-Pin Green

Connector

20-Pin Gray

Connector

4-Pin

Connector

Cap or insulate if

not being used

3.5MM SWC CABLE

Plug in the 3.5MM SWC cable to the 4-pin port

on the module. See “DIP SWITCH SETTINGS” section.

Audio Input

Rear Camera (IO3)

LIN BUS (Green/Black)

Antenna Adapter

(Included)

24-Pin

Connector

8-Pin

Connector

NON BOSE

10-Pin

Connector

SWC DIP   SWC

1     2     3      4

ON

Chime Volume

Adjustment

1     2     3

ON

VR Activation

for OnStar (set DIP#1 to ON)

JVC/Kenwood (Blue / Yellow)

Содержание SOOGM-19L

Страница 1: ...SOOGM 19L MODULE SOOGM 19L HARNESS SWC CABLE ANTENNA ADAPTER SOOGM 19L OnStar Radio Replacement Interface with Steering Wheel Control Retention for GM LAN v2 LIN Bus Vehicles 2014 2018 AFTERMARKET RADIO Reverse Red White Illumina on Orange 12V Constant Yellow 12V ACC Red Ground Black Entertainment Turn On Blue White Parking Brake Yellow Black Vehicle Speed Sense Purple White Right Front Gray Right...

Страница 2: ...E AMPLIFIER BYPASS For vehicles equipped with a factory Bose amplifier extend the speaker wires of the SOOGM 19L harness and connect to the Bose amplifier output wires Locate the Bose amplifier to find out how much speaker wires is neccessary The Bose amplifier is located as follows NOTE Bose amplifiers are commonly found in the locations listed below but the manufacturer can mount it elsewhere In...

Страница 3: ...hime and Retained Accessory Power RAP functions Reverse the process to install the new aftermarket radio The SOOGM 19L is prewired with an RCA connector to retain the OEM camera on vehicles with a IO3 system To retain the OEM camera on IO4 IO5 and IO6 systems you will need connect an RCA cable to the 12 pin connector on the HMI module found either by the passenger kick panel or behind the glove bo...

Страница 4: ... ON ON OFF OFF ON ON OFF OFF OFF OFF ON ON OFF OFF ON ON ON OFF ON OFF ON OFF ON OFF OFF OFF OFF ON OFF OFF NOTE For Blaupunkt Dual Farenheit Power Acoustik Soundstream and most off brand radios check the aftermarket radio s manual to see if the SWC buttons need to be programmed SWC MODULE DIP SWITCH 1 2 3 4 ON BUICK 2015 2016 ENCORE 2017 ENVISION 2016 LACROSSE 2014 2015 REGAL CADILLAC 2015 2016 A...

Отзывы: