F1AB-20HM01 A0
F1AB
F1AB
INSTRUCTION MANUAL
ELECTRICAL FRYER - MODEL: F1AB-20HM01 A0
-Please read these instructions carefully before operating this appliance.
-The temperature is thermostatically controlled between the range of 80
°
C to 200
°
C(176
°
F to 392
°
F). A
signal lamp adjacent to the thermostat indicates when the heating element is energized.
SAFETY
-This appliance is designed to operate on alternative current (A.C.) Only.
-DO NOT CONNECT TO DIRECT CURRENT (D.C.).
-Care should be taken when operating this appliance, as HOT SURFACES may cause burns.
-
WARNING!
Hot oil can cause burns. Spilling oil can cause severe burns. Do not move fryer without
draining all the oil from the tank.
-The unit is equipped with a manual reset, excessive temperature Safety Thermostat, which will turn off
the heating element when the oil reach a temperature of 227ºC (440ºF). Do not reset the thermostat until
the oil temperature is below 150ºC (302ºF).
-Reset button is located underneath installation box and to reset is necessary to remove the cap and to
press the red button.
-Do not over fill baskets. Carefully load them into hot oil. A danger of surge boiling can also occur if the
food to be fried is excessively wet or the frying basket is too full.
-It is dangerous to use old oil as this can reduce the flash point and cause surge boiling.
-Ensure that power supply cord does not come into contact with hot surfaces.
- When not in use for long period unplug the appliance.
INSTALLATION AND OPERATION
-Before connecting your appliance check if voltage of your power system corresponds to the unit
label.
-
For safety reasons this unit is also equipped with a switch that turns off the heating element when
the installation box is
removed
or
not correctly positioned
.
-Fill each container with 4,5 or 3,0 liters (according to the size) of quality oil (fat).
-Set thermostat to desired operation temperature (table 1) and pilot light will turn on. As soon pilot
light turns off, appliance has reached desired temperature .
-The basket should be filled up to 2/3 of the capacity.
-To turn off your unit turn knob completely towards left.
CLEANING PROCEDURE
-Always ensure that the appliance is disconnected from the main power supply before cleaning.
-Wait until oil cools and proceed as follows:
- Remove installation box.
- Remove oil container and empty the oil.
-Appliance should not be cleaned with a water jet or immersed in water. Use only a damp cloth or sponge
dipped in soapy water.
-Wipe off appliance with a dry cloth and wait at least half an hour before re-connecting to main power
outlet.
WARNING!
- UNPLUG THE APPLIANCE AFTER USE.
CROYDON
CROYDON
T
h
e
p
ic
tu
re
s/
d
ra
w
in
g
s
ar
e
ill
u
st
ra
ti
o
n
s.
A
ll
d
at
a
ca
n
b
e
ch
an
g
ed
w
it
h
o
u
t
n
o
ti
fi
ca
ti
o
n
.
CROYDONMAQ INDUSTRIAL LTDA.
Estrada São Lourenço, 891 - Capivari
Duque de Caxias - RJ / Brasil - CEP 25243-150
Phone: 55 21 2777- 8100 / 55 21 2777-8106
e-mail: [email protected]
