Crown International
P.O. Box 1000
Elkhart, IN 46515-1000
TEL: 574-294-8200
FAX: 574-294-8FAX
www.crownaudio.com
7/02 134349-2
Crown’s Three-Year, No-Fault, Fully Transferable Warranty
Crown offers a Three-Year, No-Fault, Fully Transferable Warranty for every new Crown ampli-
fi er—an unsurpassed industry standard. With this unprecedented No-Fault protection, your new
Crown amplifi er is warranted to meet or exceed original specifi cations for the fi rst three years of
ownership. During this time, if your amplifi er fails, or does not perform to original specifi cations,
it will be repaired or replaced at our expense. About the only things not covered by this warranty
are those losses normally covered by insurance and those caused by intentional abuse. And the
coverage is transferable, should you sell your amplifi er.
See your authorized Crown dealer for full warranty disclosure and details. For customers outside
of the USA, please contact your authorized Crown distributor for warranty information or call
574-294-8200.
XLS 402
TX
Specifi cations subject to change without prior notice. Latest
information available at www.crownaudio.com.
Crown is a registered trademark of Crown International.
Printed in U.S.A.
© 2002 Crown Audio, Inc.
Input/Output
Input Connectors:
One per channel; back-
panel three-pin female XLR input connectors
are provided.
Input Impedance
(nominally balanced, nomi-
nally unbalanced): 20 k ohms, 10 k ohms.
Output Connectors:
One pair of back-panel,
5-way binding posts per channel; accepts
banana plugs, spade lugs or bare wire. (Euro-
pean models do not accept banana plugs.)
DC Output Offset
(shorted input): ±10 millivolts.
Output Signal:
Stereo, unbalanced, two-
channel.
Protection
XLS
TX
Series amplifi ers provide extensive pro-
tection and diagnostic capabilities, including
built-in anti-clip limiters, switchable high-pass
fi lters, output current limiting, DC protection,
fuses, and special thermal protection for the
unit’s transformers.
Construction
Ventilation:
Flow-through ventilation from
front to back.
Cooling:
Internal heat sinks with forced-air
cooling for rapid, uniform heat dissipation.
Air Volume Requirements
(per minute per
unit): 80.15 ft³ (2.27 m³).
Dimensions:
EIA Standard 19-inch (48.3-cm)
rack mount width (EIA RS-310-B), 5.25-inch
(13.3-cm) height and 12.6-inch (32.0-cm)
depth behind the mounting surface.
Weight
Net Weight:
31 lbs. (14.0 kg).
Shipping Weight:
38 lbs. (18 kg).
