background image

100501-1

8/96

Printed on

recycled paper.

MT–BB

© 1996 by Crown International, Inc., P.O. Box 1000, Elkhart, IN 46515-1000
U.S.A. Telephone: 219-294-8000. Fax: 219-294-8329. 

P.I.P. modules are

produced by the Professional Audio Division of Crown International, Inc.
Trademark Notice: 

CSL™ is a trademark and Crown

®

 and 

Micro-Tech

®

 are

registered trademarks of Crown International, Inc. Other trademarks are the
property of their respective owners.

MT-BB

+

+

C H - 2   I N P U T

C H - 1   I N P U T

For Technical Support contact:

Crown Audio Division Technical Support Group

Plant 2 SW, 1718 W. Mishawaka Rd., Elkhart, Indiana 46517 U.S.A.

Phone: 

800-342-6939

 (North America, Puerto Rico and Virgin Islands) or 219-294-8200

Fax: 219-294-8301   Fax Back: 800-294-4094 (North America only) or 219-293-9200

Internet: http://www.crownintl.com

Содержание MT-BB

Страница 1: ...Crown and Micro Tech are registered trademarks of Crown International Inc Other trademarks are the property of their respective owners MT BB C H 2 I N P U T C H 1 I N P U T ForTechnicalSupportcontact Crown Audio Division Technical Support Group Plant 2 SW 1718 W Mishawaka Rd Elkhart Indiana 46517 U S A Phone 800 342 6939 North America Puerto Rico and Virgin Islands or 219 294 8200 Fax 219 294 8301...

Страница 2: ... of the top side of the Main Cir cuit Board and should only be at tempted by a qualified technician The barrier block connector is wired as follows Negative Input inverting Signal Ground Positive Input non inverting Both balanced and unbalanced input wiring are shown in Figures 1 2 and 1 3 opposite Please note the jumper between pins 1 and 3 when connect ing an unbalanced line to the input C H 2 I...

Страница 3: ...ne jacks and level control shafts clear the rear panel then carefully lift the rear of the board to expose its top side Figure 2 2 Fig 2 1 Inside an Amplifier WARNING TO PREVENT ELECTRIC SHOCK THIS ACCESSORY SHOULD ONLY BE INSTALLED BY QUALIFIED SERVICE PERSONNEL 2 Installation CAUTION The MT BB should only be installed by qualified service per sonnel in the following manner 1 Turn down the level ...

Страница 4: ...d face the rear with the black wire on the left and the green wire on the right 7 Fasten the MT BB panel in place us ing the screws provided and reas semble the amplifier by reversing steps 4 through 2 IMPORTANT Check that no wires impede the fan rotation 8 Restore power to the unit and read just the level controls Fig 2 2 Installing an MT BB FRONT BOTTOM VIEW J1 ROUTE THE MT BB CABLE THROUGH THE ...

Отзывы: