ZONES:
Zone 1 _____________________
___
Zone 2 _____________________
___
Zone 3 _____________________
___
Zone 4 _____________________
___
Zone 5 _____________________
___
Zone 6 _____________________
___
Zone 7 _____________________
___
Zone 8 _____________________
___
Zone 9 _____________________
___
Zone 10 _____________________
___
Zone 11 _____________________
___
Zone 12 _____________________
___
Zone 13 _____________________
___
Zone 14 _____________________
___
Zone 15 _____________________
___
Zone 16 _____________________
___
Stay
Mode
Delay
Chime
1) Dial your home from any touch tone phone the panel will pickup the line
after your programmed number of rings with a continuous tone for 5
seconds, (fax bypass is also optional).
2) Key your 4 digit code, after the 5 second tone, for the area you wish to
control. You can control and confirm the status of your alarm panels 3
separate partitions. Toggle between arm and disarm with the "*" key.
3) Key your 4 digit code for output control after the 5 second tone.
e.g. If your code for output control is 1234 and you wish to turn on output 5.
When the panel picks up your incoming call and after the 5 second tone,
simply key in 1234 followed by 5. Your voice message will give you the
current status of out put 5. To change the status toggle on or off using the
"*" key.
4) If you make a mistake at any stage, press the "#" key and re-enter your
code.
5) When finished simply hang up and the panel will disconnect
automatically after 15 seconds.
The Keypad
Your PW-16 Alarm Controller has been designed with you the user in mind.
Clearly named backlit keys may cost a little more but mean you don't have
to remember difficult key combinations to achieve a result. As with
everything about the PW-16 even key functions can be fine tuned to your
specific needs. Please ask your installer.
The ARM Key
Press this button to arm your system, the Armed light will come on. Your
panel will begin beeping it's exit delay. During this time it is optional to press
the
[ARM ]
key again to disarm. (To prevent accidental arming, the panel
can be programmed to require a code to arm. To do so enter your code
followed by the
[ENTER]
key).
To disarm, enter your 1 to 6 digit code then press the
[ENTER]
key.
If your system has the Wireless Receiver installed, your system can also be
armed or disarmed with a Remote Control.
