Cronyx E1-XL/B-IP, Инструкция по установке и эксплуатации

Страница: 44 / 48

E1-XL/B-IP Multiplexor
© 2006 Cronyx
4.4.2. Command “Status | Clear”
The given command is used to reset errors and events counter, clear statistics and
history of device operation.
4.4.3. Menu “Status | System tables”
It is used to view some critical system tables and registers:
«Messages»
– core message register;
«Processes» – process list;
«Interfaces» – network interface table;
«ARP»
– ARP cache contents;
«Routing»
– network routes list;
«Connections» – network connections list;
4.4.4. Command “Status | Firmware”
The given command is used to view device firmware detailed report.
4.5. Menu “Testing”
Menu “Testing” is used to test operability of device and its related equipment.
4.5.1. Menu “Testing | E1 Interface”
Menu “Testing | E1 Interface” is used to control to E1-port loopbacks. Active loopback
modes are not saved in nonvolatile memory. The following options are available:
•
«Normal»
– normal operation without loopbacks;
• «Mirror» – “mirror” mode. Data received from E1 port is turned back
to E1 port without processing and is transferred to a remote device over packet
network. Data received from the remote device over packet network is lost;
•
«Loopback»
– “loopback” mode. Data received from a remote device over
packet network is processed by the device, transferred to E1 port and replaces
data received from E1-port;
•
•
•
•
•
•