A
C.R. LAURENCE Co., INC.
Visit us at
crlaurence.com
for international toll free information 10
PLUNGE CUTTING
Plunge cut into plywood and thin board panels.
Do not attempt to plunge cut into thick, hard wood
or metal panels.
1. Clearly mark the line of cut.
2. From a convenient starting point within the cutting
area, place the tip of the Blade over that point with
the Saw parallel to the line of cut.
3. Place the edge of the Pivot Shoe on the work piece
with the Blade NOT touching the work material.
Squeeze the Trigger to start the tool operating. Never
start a plunge cut with the Blade tip touching the work
piece. This will cause an immediate kick back, can
cause personal injury and/or damage to the work piece or blade.
4. Wait for the Saw to reach full speed, then slowly rotate
the tool on the Pivot Shoe as the Blade contacts the work piece.
5. Continue to slowly rotate the tool until the Blade has penetrated through the work material.
Press the Pivot Shoe firmly against the work material and continue to make the cut.
6. When the cut is complete, turn off the tool. Allow the tool to stop completely before removing
it from the cut.
7. To prevent accidents, turn off the tool and disconnect its power supply after use.
Clean, then store the tool indoors out of the reach of children.
METAL CUTTING
1. Install a metal cutting blade and adjust the Handle.
2. Coat the cutting surface with cutting oil to prevent the blade from overheating.
3. Follow general cutting procedure, see "General Cutting" on page 10.
4. To prevent accidents, turn off the tool and disconnect its power supply after use.
Clean, then store the tool indoors out of the reach of children.
mAINteNANCe AND seRvICING
pRoCeDURes Not speCIfICALLy eXpLAINeD IN tHIs mANUAL mUst Be
peRfoRmeD oNLy By A QUALIfIeD teCHNICIAN.
to pReveNt seRIoUs INJURy fRom ACCIDeNtAL opeRAtIoN:
Squeeze the
release Trigger and unplug the tool from its electrical outlet before performing any
procedure in this section.
to pReveNt seRIoUs INJURy fRom tooL fAILURe:
Do not use damaged
equipment. If abnormal noise or vibration occurs, have the problem corrected
before further use.
Line of Cut
Shoe
Rotation Tool on
Pivot Shoe