OPTION PROGRAMMING STEPS / CHART
Follow steps below to access Programming Options:
1. Turn the ignition on and press the override/program button 5 times within 5 seconds. You will hear a (2) Second
confirmation chirp from the siren.
2. Within the next 5 seconds press the override/program button [again] the number of times that corresponds to the
listed feature below. The siren will chirp once for each button press.
3. Once you are at the desired option number, press Button (I) or (II) on the remote to change the option. When
pressing button (II) you must hold it down 2-3 seconds until the remote beeps. Button (I) gives on light flash/chirp
and Button (II) give two flashes/chirps. See chart below for option selections. Turn OFF Ignition.
4. Change ONE option at a time and repeat steps 1-3 as needed.
Option # Option Description
Selection
Button (I)
Button (II)
Factory
Default
1.
Passive Arming
ON or OFF
ON
OFF
ON
2.
Passive Locks
ON or OFF
ON
OFF
ON
3.
Active Re-Arm
ON or OFF
ON
OFF
ON
4.
Silent Arm/Disarm
ON or OFF
OFF
ON
OFF
5.
Double Unlock Pulse
ON or OFF
OFF
ON
OFF
6.
Door Lock Pulse Time
0.7 Sec. or3 Sec.
0.7 Sec.
3 Sec.
0.7 Sec.
7.
Ignition Controlled Locks
ON or OFF
ON
OFF
ON
8.
Enable/Disable Cold Start
ON or OFF
OFF
ON
OFF
9.
Cold Start Interval Time
Every 2 Hrs. or 1 hr.
2 Hrs.
1 Hr.
2 Hrs.
10.
Disarm with Aux. Feature
Activation (Trunk Pop)
ON or OFF
OFF
ON
OFF
11.
Chirp Countdown w/Passive
Arming
ON or OFF
OFF
ON
OFF
12.
Open Zone Warning
10 or 60 Sec.
10 Sec.
60 Sec.
10 Sec.
13.
Remote Start Run Time
15 Min.or 25 Min.
15 Min.
25 Min
15 Min.
14.
Doors Lock with Remote Start ON or OFF
ON
OFF
ON
15.
Lock After Aborted Remote
Start
ON or OFF
ON
OFF
ON
16.
Parking Lights ON w/Disarm
ON or OFF
OFF
ON
OFF
1. PASSIVE ARMING
ON
= Arming will occur 30 Seconds after the ignition is turned off and the last door has been closed. The LED will
flash rapidly during count down.
OFF
= System arming is controlled through remote only.