Crestron TPMC-9L, Руководство по эксплуатации и установке

Страница: 35 / 52

Crestron TPMC-9L Isys
®
9” Wall Mount Touch Screen
Touch Screen Removal
If it is necessary to remove the touch screen after it has been installed into a
mounting surface, complete the following steps in the order provided to remove the
touch screen. The only tool required is a #2 Phillips tip screwdriver.
1. Lift one edge of the faceplate to free it from the touch screen and lift it off.
Do not apply excessive pressure to the touch screen.
2. Loosen and remove the screws that secure touch screen to the mounting
option in use.
3. Using equal pressure, carefully remove the touch screen from the opening.
If necessary, secure and label the attached cables before disconnecting them from the
back of the touch screen.
Hardware Hookup
Ventilation The TPMC-9L should be used in a well-ventilated area. The venting holes should not
be obstructed under any circumstances. If the TPMC-9L is hot to the touch, consider
using forced air ventilation.
To prevent overheating, do not operate this product in an area that exceeds the
environmental temperature range listed in the table of specifications. Consideration
must be given if installed in a closed or multi-unit rack assembly since the ambient
operating temperature of the environment may be greater than the ambient room
temperature. Contact with thermal insulating materials should be avoided on all sides
of the unit.
Connect the Device Make the necessary connections as called out in the illustration on the following
page. Refer to “Network Wiring” on page 12 before attaching the 4-position terminal
block connector. Apply power after all connections have been made.
When making connections to the TPMC-9L, use Crestron power supplies for
Crestron equipment.
Operations & Installation Guide – DOC. 7030B Isys
®
9” Wall Mount Touch Screen: TPMC-9L
•
31