Crestron TMK-12L, Руководство по установке

Страница: 10 / 16

Trim Ring Mount Kits Crestron TMK-12L & WMKT-12L
TPS-12L Mounting Using the TMK-12L – Exploded View
PMK-12L
TPS-12L
(Bezel Removed)
TRIM RING
(2013001)
DRYWALL
(Bezel)
MOUNTING SCREWS (8)
#06-32 X 1-1/2" (2007254)
NOTE: MOUNTING SCREWS
SUPPLIED WITH TOUCHPANEL.
WMKT-12L Procedure
This section provides the necessary steps for the assembly and installation of the
WMKT-12L into a wall. Review the procedure first, then complete the steps in the
order provided. The only tools or materials required and not supplied are a drywall
saw or equivalent and a level.
CAUTION: Allow an air gap of at least 12 inches (30.48 cm) in the wall cavity
above and below the touchpanel for heat dissipation.
1. Locate an area on the wall that is free of miscellaneous wiring and studs.
2. Make a small hole near the middle of the designated site; verify that the
location is suitable.
NOTE: Make the cutout as level and smooth as possible. The mounting plate allows
for only minor leveling adjustments. If a larger cutout is made accidentally, consider
purchasing the Crestron Mud Mount Kit, MMK-12L. Together with the mounting
plate supplied with the WMKT-12L, it provides a cost-effective means of correction.
Essentially, the combination of these two kits makes up the Crestron Mud Mount Kit
for the wall, WMKM-12L. Simply follow the “WMKM-12L Procedure” in the latest
revision of the Mud Mount Kits Installation Guide (Doc. 6359).
3. Use the drywall saw or equivalent and the provided drywall cutout template
to produce an accurate, clean and level cutout in the drywall.
6
•
Trim Ring Mount Kits: TMK-12L & WMKT-12L Installation Guide – DOC. 6360A