Crestron Sonnex SWAMP(I)-24X8, Руководство по эксплуатации

Страница: 39 / 56

Crestron
SWAMP(I)-24X8
Sonnex Multiroom Audio System
Operations Guide – DOC. 7049E Sonnex Multiroom Audio System: SWAMP(I)-24X8
•
33
Bridge Outputs
To bridge outputs together, perform the following procedure:
1. Enter the “Zone Setup” menu as described in “Enter/Exit the “Zone Setup”
Menu” on page 28.
2. Press
q
or ▲ to display Bridging and press ENTER . A list of zones is
displayed.
3. Press
q
or ▲ to display the zone to be configured and press ENTER . The
Bridging
screen is displayed.
NOTE: Since only odd-numbered zones can be bridged with their
respective, adjacent, even-numbered zones, only odd-numbered zones are
listed. Refer to “Bridge Speaker Outputs” on page 22 for details.
Bridging Screen
Zone 1
Bridging On q
4. Press
q
or ▲ to display the desired bridging setting and press ENTER .
NOTE: Bridged outputs are indicated with LEDs near the speaker terminals
on the rear of the SWAMP-24X8 and SWAMPE Multiroom Audio
Expander.
5. Repeat for every zone to be bridged/unbridged.
6. Press MENU to return to the “Zone Setup” menu.
Set Speaker Wattage Rating
To specify the wattage of speakers connected to a zone output, perform the following
procedure:
1. Enter the “Zone Setup” menu as described in “Enter/Exit the “Zone Setup”
Menu” on page 28.
2. Press
q
or ▲ to display
Wattage
and press ENTER . A list of zones is
displayed.
3. Press
q
or ▲ to display the zone to be configured and press ENTER . The
Wattage screen is displayed.
Wattage Screen
Zone 1
Wattage 240 W q
4. Press
q
or ▲ to display the speaker’s wattage rating and press ENTER .
NOTE: If the speaker rating is not displayed, select the next-lowest rating
to avoid damage to the connected speakers.
5. Repeat for every zone to be configured.
6. Press MENU to return to the “Zone Setup” menu.