Crestron
ST-CP
SmarTouch™ Control Processor
Leading Specifications
The table below provides a summary of leading specifications for the ST-CP.
Dimensions and weight are rounded to the nearest thousandth unit.
Leading Specifications of the ST-CP
SPECIFICATION
DETAILS
Power Requirements
12 or 24 VDC
SIMPL™ Windows®
Version 1.20.01 or later*
VisionTools™ for Windows®
Version 10.7 or later*
VT Pro
Version 1.1.7 or later*
ST-CP Operating System
Version 4.00.52s or later*
ST-CP Monitor
Version 1.36 or later*
Crestron Database
Version 11.7.210 or later*
Dimensions & Weight
Height: 1.70 in (4.32 cm)
Width: 7.07 in (17.95 cm)
Depth: 6.32 in (16.06 cm)
Weight: 2.00 lb (0.95 kg)
*
The latest software versions can be obtained from the Software Downloads page (SIMPLWIN,
TOUCHPNL, OPSYS, and CRESDB Libraries) of Crestron’s website (
www.crestron.com)
. New users
are required to register in order to obtain access to the FTP site.
As of the date of manufacture, the unit has been tested and found to comply with
specifications for CE marking.
Preparation for Use
The ST-CP provides two roles as an integral part of the SmarTouch STS. First, it
stores the project programmed with SmarTouch software via the PC. It also receives
RF signals from the user interface and transmits commands to A/V equipment or
peripheral pieces of SmarTouch equipment, during normal operation. The following
paragraphs detail the connections that must be made to the ST-CP in each role.
Programming
When programming, refer to figure that follows this paragraph for a typical
connection diagram. Complete the following steps in the order provided to ensure
proper connection.
NOTE:
The PC to control processor and touchpanel to control processor cables only
need to be attached when programming.
NOTE:
The procedure that follows assumes that a touchpanel is being used as the
user interface. No connections to the user interface need to be made, if a wireless
hand-held transmitter is utilized.
Operations Guide - DOC. 5820
SmarTouch™ Control Processor: ST-CP
•
5
