Product Manual — Doc. 9321A
IV-CAMFL-N-W-1B • 19
2. To change the camera’s network settings to match your network’s IP scheme, click Modify
netinfo which will bring up the network settings panel.
3. Under Network information, confirm that the ConnType (Connection Type) is correct for
how the camera is connected. It can be set to either Static IP or DHCP.
By default, the camera ships with the static IP address
192.168.18.77
and a subnet mask of
255.255.255.0
.
If the Ethernet cable is connected directly to the computer running the
1 Beyond Camera Manager software, the computer’s network port will need to be set to
an address on the same subnet (for example, 192.168.18.78) in order to communicate with
the camera.
If the camera is connected to a network switch, the camera’s IP address needs to be
changed to DHCP or to a static address within the same subnet as the computer running
the software.
If the installation requires a different static address (for example, The IP address of the
camera needs to be modified to match the subnet of the computer), enter the IP, Mask
and Gateway info and then click Modify.
4. After modifying the IP address, click Refresh to update the camera list.
5. Select the camera and click Add to Camera List. This brings up the Add panel where you
can verify that the camera’s network settings are correct. By default, 1 Beyond cameras do
not require any administrator credentials to be controlled. Once added, the camera will
appear in your camera list.
The camera should show as connected in both the Close-Up and Panorama columns,
signifying that 1 Beyond Camera Manager is able to receive both IP video streams from
the camera.
6. If the status reads
Connection Failed
or
Disconnect
, double-check the IP address of the
camera and the computer to be sure they are on the same subnet so the two can
communicate via IP.
Access Video Feeds
Proceed to the Main View tab to monitor the video feeds and begin setting up the tracking
parameters. In the Camera List, right-click on the camera name and select Close Up and
Panorama to add the streams the multi view area. The tracking shot and the full-room view
appear side-by-side.
