Crestron FT-TSC600 FlipTop, Руководство по эксплуатации и установке

Страница: 33 / 48

Crestron FT-TSC600 FlipTop Touch Screen Control System
Operations & Installation Guide – DOC. 7593A FlipTop Touch Screen Control System: FT-TSC600 • 29
Supplied Hardware
The hardware supplied with the FT-TSC600 is listed in the following table.
Supplied Hardware for the FT-TSC600
DESCRIPTION PART NUMBER QUANTITY
Metal, Plate, Mounting 2036985 2
Screw, 10-32 x 2”, Steel, Socket HD, Zinc 2037109 4
Small Hole Plug 2036647 4
Large Hole Plug 2036649 4
Small Bushing, 5/16” ID, 0.5” OD 2009522 4
Large Bushing, 0.55” ID, 0.80” OD 2010496 4
Installation
NOTE: To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the table of specifications.
Consideration must be given if installed in a closed assembly, inside a closed desk or
in a closed podium since the operating ambient temperature of these environments
may be greater than the room ambient temperature. Contact with thermal insulating
materials should be avoided on all sides of the unit.
Cable Management Plates
The FT-TSC600 ships with two cable management plates pre-installed. These
provide a pullout cable solution for the AUD OUT (audio output) COMPUTER and
LAN cables. A 6 foot (1.8 meter) USB Type A to Type B cable is included for the
COMPUTER
connection. Cables are looped through the cable management plates.
The included bushings must be installed before mounting the FT-TSC600 in a
surface. For a neat appearance, any unused openings can be filled using the included
hole plugs. The only tool required is a Phillips screwdriver.
1. Remove the two cable management plates and retain the 06-32 x 1/4” screw
that holds each one in place.
2. Place the bushings on the cables (eight bushings supplied).
3. Thread the cables through the appropriate slots on each plate.
4. Snap the bushings into the plate slots.
5. Feed all excess cable through the opening.
6. Attach each plate by first sliding its dovetail into the slot toward the rear of
the inside of the FT-TSC600, then dropping the front into place and
securing it with the 06-32 x 1/4” screw from step 1. Refer to the following
illustration.