Crestron DM-RMC-200-S, Руководство по эксплуатации и установке

Страница: 36 / 44

DigitalMedia 8G Fiber Receiver 200 Crestron DM-RMC-200-S/S2
Problem Solving
Troubleshooting
The following table provides corrective action for possible trouble situations.
If further assistance is required, please contact a Crestron customer
service representative.
DM-RMC-200-S/DM-RMC-200-S2 Troubleshooting
TROUBLE POSSIBLE CAUSE(S) CORRECTIVE ACTION
PWR LED
does not
illuminate.
Device is not receiving
power. Verify power pack connections
to the device and to the power
outlet.
PWR LED
flashes.
Memory test fails while
the device boots up. Power cycle the device.
DM IN LED
blinks once a
second.
Device cannot establish
a link to the device
connected to the
DM IN port.
Verify cable connection to the
DM IN port.
Device is not receiving
video signal. Ensure proper video signal is
routed to device.
VIDEO LED
does not
illuminate.
Device connected to the
HDMI OUT port has not
sent the hotplug signal.
Power on device connected to
the
HDMI OUT port and ensure
that it is switched to the correct
input.
VIDEO LED is
green but
video on
connected
display is
black.
HDCP is blanking the
video output. Verify that device connected to
HDMI output supports HDCP.
Amplifier is turned off or
EDID is not configured
properly. In DMTool, confirm that Enable
Analog Audio Outpu t is
selected.
There is no
sound from
connected
speakers.
Volume is turned down. In DMTool, move the volume
slider up as necessary to
increase the volume.
(Continued on following page)
30

DigitalMedia 8G Fiber Receiver 200: DM-RMC-200-S/S2 Operations & Installation Guide – DOC. 7246B