Crestron DM-NVX-E760, Руководство по эксплуатации продукта

Страница: 37 / 52

Product Manual — Doc. 8918B DM-NVX-E760 and DM-NVX-E760C • 33
Network Port Selection
Network port selection enables network traffic to be managed and segregated based on traffic
type. Internal VLANs are used to route different traffic types to specific external Ethernet ports,
which can then be assigned to the various traffic types. AES67 audio can be separated from the
primary video and control network resulting in a dedicated audio network.
CAUTION: When network port selection is set to Off (default setting), multiple Ethernet ports
cannot be connected to the same Ethernet switch. Doing so will cause a network loop and bring
down the network.
NOTE: If network port selection is enabled, daisy chain configuration is not supported.
To configure network port selection:
1. Click the Settings tab and then click Port Selection.
2. Enable or disable network port selection by setting the Port Selection toggle switch in the
On (right) or Off (left) position, respectively. The default setting is Off.
3. If Port Selection is set to On, assign each of the following traffic types to a specific
Ethernet port:
l
Management (default setting is port 1). Ethernet ports 1, 2, and 3 are available for
use.
NOTE: The management port controls the connection to the DM NVX web
interface. Changing the port number will result in losing the connection to the web
interface.
l
Video (default setting is port 1). Ethernet ports 1, 2, and 3 are available for use.
l
Audio/NAX (default setting is port 1) Ethernet ports 1, 2, and 3 are available for use.
4. Click Save Changes to apply the new settings.