2
•
DM-MD8X1-4K-C and HD-MD8X1-4K: 4K Scaling Auto-Switchers
Supplemental Guide – DOC. 7718B
Physical Description
This section provides information about the connectors, controls, and indicators on the front
and rear panels of the DM-MD8X1-4K-C and HD-MD8X1-4K.
Front Panel
The following illustration shows the front panel of the DM-MD8X1-4K-C.
NOTE:
For illustrative purposes, the front panel of the DM-MD8X1-4K-C is shown below.
The front panel of the HD-MD8X1-4K is the same as the front panel of the
DM-MD8X1-4K-C.
Front Panel (DM-MD8X1-4K-C Shown)
COMPUTER: USB Type B female;
USB computer console port;
For setup only
PWR: Bicolor green/amber LED, indicates operating power supplied from ac line
power, turns amber while booting and green when operating
MSG: Red LED, indicates an error message has been generated
HW-R: Recessed push button for hardware reset, reboots the device
SW-R: Recessed push button for software reset, restarts the software program
SETUP: (Applicable only to a configuration in which a DigitalMedia™ switcher is not
used) Red LED and recessed push button for Ethernet setup of the default static IP
address of the device
NOTE:
The default static IP address of the DM-MD8X1-4K-C is 192.168.1.200.
The default static IP address of the HD-MD8X1-4K is 192.168.1.201.
IR IN: Infrared sensor;
IR Frequency: 36 to 38 kHz;
IR Formats: Crestron format, RC5;
Allows control from IR wireless remotes using the Crestron or RC-5 command sets
NOTE:
If the DM-MD8X1-4K-C or HD-MD8X1-4K is used without a control system, the
IR IN sensor cannot be used. The IR IN sensor can be used for fully customizable
applications through integration of the DM-MD8X1-4K-C or HD-MD8X1-4K with an
external 3-Series
®
Control System with custom programming.
AUTO INPUT SELECT: Push button and bicolor green/amber LED, selects
auto-switching mode
VGA INPUT SELECT 1-4: Push buttons for manual input selection and corresponding
bicolor green/amber LEDs that indicate the current active input and signal presence at
each corresponding VGA input
