Crestron CLF-DIMRFB, Руководство по эксплуатации, Страница: 20 / 28

InfiNET
™
Lamp Dimmer Crestron CLF-DIMRFB
Special Functions
Enter ACQUIRE Mode
Before an infiNET device can be used on an infiNET network, it must
first be acquired by a C2N-MNETGW gateway that is connected to a
Cresnet network.
NOTE : A dimmer can be acquired by only one gateway.
To acquire a CLF-DIMRFB by a C2N-MNETGW, perform the
following:
1. Put the C2N-MNETGW in the ACQUIRE mode, from the unit
itself or from Toolbox, as described in the latest revision of the
C2N-MNETGW guide (Doc. 6317) which is available from the
Crestron website.
NOTE : In environments where multiple gateways are installed, only
one gateway should be in ACQUIRE mode at a time.
2. Place the CLF-DIMRFB in the ACQUIRE mode by doing the
following:
a. Move the mode selection switch to the “OFF” position.
b. Press and hold the foot switch, while sliding the mode
switch to the “RUN” position.
c. Continue holding the foot switch until you see the LED
blink once. Now release the foot switch; the unit is now in
ACQUIRE mode.
NOTE : ACQUIRE mode does not actually start until the foot
switch is released.
After approximately 10 seconds, the LED will start to blink slowly
and the dimmer will attempt to acquire with a C2N-MNETGW that
is in the
ACQUIRE mode. The device is acquired then the LED
stops blinking. Acquiring can take up to five minutes to complete.
After being acquired, the device will exit the
ACQUIRE mode.
3. Take the C2N-MNETGW out of the ACQUIRE mode once all
devices have been acquired. Refer to the latest revision of the
C2N-MNETGW guide (Doc. 6317).
16
•
infiNET
™
Lamp Dimmer: CLF-DIMRFB Operations Guide – DOC. 6479