Product Manual — Doc. 9310A
CAEN-UMP1X2-DIN-PWS • 11
To install the DIN-AP4:
1. Attach the DIN-AP4 to the DIN rail next to the DIN-HUB. Refer to the
for details.
2. Use a small flat-head screwdriver to secure the end clamp next to the DIN-AP4. Tighten to
9 in.-lbs (1.02 nm).
3. Connect six of the terminal blocks included with the DIN-AP4 or save them for future use.
Refer to the diagram for placement.
Wire the DIN Rail Products
To connect the DIN products, use the following equipment included with the
CAEN-UMP1X2-DIN-PWS:
l
2-wire cable with flying leads on one end and a 2-pin terminal block on the other
l
4-wire cable with 4-pin connectors
l
Two tie wraps
