Crestron BB-4000L, Руководство по установке

Страница: 8 / 12

Wall Mount Back Box Crestron BB-4000L
Mounting
Required Tools:
#2 Phillips tip screwdriver or hammer
Level
Complete the following procedure (refer to illustration below) to mount the
assembly.
1. Position assembly to front edge of stud and align it as even and as flush
as possible.
2. Use the level and verify that the back box is horizontal. Leveling must
be done before proceeding.
3. Attach the assembly to the left or right side of the stud with standard
drywall screws or nails (supplied by other). If the mounting brackets
cannot be used due to the box location (i.e. above/below a crossbeam),
remove the brackets and attach the assembly to the left or right side of
stud using the four holes on the side of the enclosure.
4. Feed cables through knockout holes.
Mounted View with Cover Plate (Mounting Example - Drywall Not Shown)
METAL COVER PLATE 2011423 (SUPPLIED)
USE TO COVER CUTOUT IN THE DRYWALL
IF TOUCHPANEL IS NOT INSTALLED
(IF REQUIRED BY LOCAL BUILDING CODES)
IT IS IMPORTANT THAT THESE 2
SURFACES BE AS EVEN AND
FLUSH AS POSSIBLE WHEN
MOUNTING BACK BOX
BACK BOX MUST BE
MOUNTED TO THE STUD
AS LEVEL AS POSSIBLE
4
•
Wall Mount Back Box: BB-4000L Installation Guide - DOC. 6305