Crestron Electronics TS-1070, Руководство по эксплуатации продукта, Страница: 75 / 166

Product Manual — Doc. 8555E TS-70 Series • 71
Connect the Touch Screen
Route all necessary cables to the touch screen, and then make connections to the bottom of the
touch screen.
Observe the following when connecting the touch screen:
l
Power and data connection is provided to the touch screen by a single Ethernet cable. A
Crestron PoE (Power over Ethernet) power supply, such as the
PWE-4803RU , or a PoE-
capable network switch is recommended (neither included).
l
The USB port is used to connect compatible Crestron LED accessories to the touch screen.
NOTE: The TS-770-GV may use either PoE or PoE+ to supply power to compatible LED
accessories over USB; the TS-1070-GV requires at minimum PoE+ to supply power to
LED accessories over USB.
l
Apply power after all connections have been made.
Install the Cable Grommet
The touch screen ships with two cable grommets that can used depending on the planned cable
route to the touch screen:
l
Use the open grommet if cables will be routed out from the rear of the touch screen. A
cable compartment cover is also provided for this installation.
l
Use the closed grommet if cables will be routed from underneath the touch screen.
To install the cable grommet:
1. If using the open grommet, push the cables into the openings in the grommet.
2. Push the grommet into its slot on the bottom of the touch screen so that the two tabs on
either side of the grommet engage the slots in the touch screen.