Creo Dolev 4press V, Руководство пользователя

Страница: 69 / 121

Before Exposing 53
Media Position
- [toggle field; default is
Punch
]
Toggle this field to
No
,
Cnt Punch
(center), or (side)
Punch
(the default), to
match the way you positioned the media inside the loading cassette (that is,
unrelated to the existence or the absence of a punch). For details, see
Chapter 2, Handling Cassettes and Media, Handling the Left Flange on
page 43.
Res/Int Table #
- [toggle field; default is
D
]
Toggle this field to
D
(the default) to automatically select a Res/Int table to
suit the vendor (if such is indicated in the Vendor field).
If the loaded film is not of the same type as the one previously loaded,
toggle this field to the appropriate Res/Intensity table number (refer
Chapter 4, Calibration and Service Utilities on page 71).
Vendor
- [toggle field; default is
None
]
Toggle this field to
None
(the default) in order to use the table specified in
the Res/Int Table field.
Toggle this field to the name of the vendor of the loaded media to use the
Res/Int table that is specified in the Res/Int Table # field.
Cur. Length (m)
- [default is
61
]
Note: The imagesetter hardware does not yet support Cnt Punch .
For example, if you have positioned the media in order to accommodate built-in
side punches, toggle the field to
Punch . The position of the left flange affects the
representation of the cassettes on the control panel (see Chapter 1, Introduction
to the Imagesetter, Status of Loading and Unloading Cassettes (or Inline
Processor)
on page 30).
Note: If the Res/Int Table specifies D, the system automatically selects a Res/Int
table to suit the specified vendor.
Note: This is the only field that updates during exposure.