Creo Dolev 4press V, Руководство пользователя

Страница: 56 / 121

40 Chapter 2 – Handling Cassettes and Media
Overview
This chapter explains how to remove the loading cassette, load film into it,
place it back in the imagesetter, and trim the film.
The following section explains how to place the unloading/accumulating
cassette in the imagesetter, and update the Media Info table.
The next section describes the exposure process, and the actions that may
be taken during it.
The last part of the chapter explains how to remove the unloading/
accumulating cassette, and process the film.
Before Starting
Before starting, make sure the following conditions are met:
•
The imagesetter is powered
ON
(see Chapter 1, Introduction to the
Imagesetter, Starting Up on page 20).
•
Both the film loading and film unloading drawers are open.
•
The
NOT READY
message appears on the control panel (see Chapter 1,
Introduction to the Imagesetter on page 13).
Before starting to expose, proceed as follows:
1.
Open the left service door (see Chapter 1, Introduction to the
Imagesetter, Opening Service Doors on page 18). The film path selector
is located on the left side of the machine.
Film path selector (set for unloading/accumulating cassette)
Note: Both drawers open automatically if the loading cassette contains no film,
or if you requested change media on the control panel. If one of the drawers is
closed, select
Open Load Drawer or Open Unload Drawer on the control
panel (see Control Panel Functionality on page 55).