Creo Dolev 4press V, Руководство пользователя

Страница: 109 / 121

System Messages 93
[ F ]
Missed Grasp pos
This message indicates that the unloading/acc. cassette is not ready to
grasp the film.
1.
Select
Util: Other: Open Unload Drawer
on the control panel.
2.
Remove the unloading/acc. cassette from its drawer.
3.
Replace the unloading/acc. cassette back into its drawer and close the
drawer.
[ F ]
Film stuck in guide
This message indicates that the film is stuck somewhere in the film
path between the unloading rollers and the unloading/acc. cassette.
[ F ]
Capture film crash
This message indicates that the film was not grasped by the unloading/
acc. cassette.
1.
Open the left service door.
2.
Close the film guide doors, close the left service door, and select
Cut
in
Service Utilities mode on the control panel.
3.
Open the left service door and the film guide lower door; pull the film
out through the left side of the imagesetter; close all doors.
[ F ]
Film crash
This message indicates that the film crashed in the drum while
advancing.
Ø
On the control panel, access Service Utilities mode, and select
Empty
Drum
. The film rolls back into the loading cassette (or into the film
loading drawer), and the film loading drawer opens.
Note: If the film is jammed in the cutter area, open the film guide lower
door, and attempt to stretch the film so it is straight in the cutter area. Pull
the film gently for it to remain attached to the drum.