background image

1 of 2

CI321X01R0_B

THE EDGE

®

   

LED Security Wall Mount

Includes: SEC-EDG-WM

INSTALLATION INSTRUCTIONS

INSTRUCTIONS D’INSTALLATION

TO INSTALL:

WALL MOUNTING

STEP 1:

IMPORTANT

 – If needed, the (2) Keyhole knockouts located 

inside box may be removed, but are for alignment only. See 

Figure 2.

 Luminaire is to be supported by (4) 3/16” mounting 

holes. The Mounting holes will accommodate a #10 bolt. 
Select appropriate customer supplied mounting hardware for 
mounting surface. See 

Figure 2 and 5.

STEP 2:

Place mounting box over junction box or conduit. If mounting 
over junction box a 2-1/2” Inspection knockout hole is 
included. See 

Figure 2 and 5.

NOTE:

 See 

Figure 4 

for minimum mounting box distance to 

achieve a required 3" clearance.

STEP 3:

For surface wiring (4) 1/2” threaded holes are available. See 

Figure 2 and 5.

STEP 4:

If mounting on a uneven surface, place a minimum of a 1/4” 
bead of high grade silicone on the black gasket encompassing 
the Inspection Knockout hole on the back of the mounting box. 
See 

Figure 5.

STEP 5:

If mounting over surface mounted conduit use the knockout 
conduit openings located on the top, bottom, or sides of the 
luminaire. Knockouts can be removed by using a hammer or 
pliers. See 

Figure 3.

STEP 6:

Before securing to wall mounting surface, make sure 
mounting box is level.

STEP 7:

Secure mounting box to wall.

STEP 8:

For ease of installation, hook the (2) installation support cable 
loops on the top screws of the mounting box. 

STEP 9:

Make wiring connections per the 

Electrical Connections

 

section on the next two pages.

1

(2) Installation 

Support Cables

Luminaire Mount 

Screws

Wiring Knockout

Conduit Knockouts

Locations

(4) Luminaire Mount Screws

Mounting Box

3

2

(2) Keyhole 

Knockouts

(4) 1/2" threaded holes

(4) Mounting Holes

(4) Mounting 

Holes

Conduit 

Knockout

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed 

including the following:

READ AND FOLLOW ALL SAFETY 

INSTRUCTIONS

1.  DANGER

- Risk of shock- Disconnect power before installation.

DANGER

 – Risque de choc – Couper l’alimentation avant l’installation.

2.  When handling, hold luminaire on sides to prevent damage to the top screen or LED’s. 

3.  This luminaire must be installed in accordance with the NEC or your local electrical 

code. If you are not familiar with these codes and requirements, consult a qualified 

electrician. 

Ce produit doit être installé conformément à NEC ou votre code électrique local. 

Si vous n’êtes pas familier avec ces codes et ces exigences, veuillez contacter un 

électricien qualifié.

SAVE THESE INSTRUCTIONS FOR FUTURE 

REFERENCE

Отзывы: