EB14SMK
Including : CR24-EB14, CR14-EB14, CR22-EB14, CR-LE-EB14
Step 1:
Unpack the CR Troffer, light engine and remote kit from its shipping
container.
Step 2: (Figure 1 & Figure 2)
Hang battery pack at one end of the troffer, opposite of the driver
enclosure.
Step 3: (Figure 3)
Run wire harness to PCB along side of troffer.
Step 4:
Attach battery side of wire harness to the battery connector located
on top of the driver enclosure.
Step 5:
Connect wire harness to driver as shown in wiring diagram below:
For Step Dimming see Figure a, for 0-10V Dimming see Figure b.
Step 6:
Complete installation with SMK instructions.
INSTALLATION INSTRUCTIONS:
b
LINE S1
UNSWITCHED HOT
VIOLET
GREY
DRIVER ASSEMBLY
BLACK
WHITE
RED
IMPORTANT SAFEGUARDS. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
SAVE THESE INSTRUCTIONS.
All servicing should be performed by qualified personnel. When using electrical equipment, basic safety precautions should always
be followed including the following: (1) Do not use outdoors. (2) Do not use this equipment for other than its intended use. (3) Before
installing this fixture or doing any maintenance, make sure to turn off the power supply at the circuit breaker or fuse box. (4) Do not
handle energized module with wet hands or when standing on wet or damp surfaces, or in water. WARNING - Risk of Electric Shock.
Access above ceiling required. Do not install insulation within 3” (76mm) of any part of the luminaire. Suitable for suspended ceil-
ings. Maximum mounting height of 10 feet. The CR Series of recessed troffers is for non-insulated ceiling applications using T-Bar
ceiling grid only. Designed for use in 120-277V 50-60 Hertz protected circuit (fuse box, circuit breaker). Supply wire sized as per NEC
or governing code(s), 90C rated.
Power
Output
Position
S1
On
On
Off
Off
S2
On
Off
On
Off
100%
50%
50%
0%
DRIVER ASSEMBLY
BLACK
BLACK
RED
WHITE
NEUTRAL
UNSWITCHED HOT
S1
LINE
S2
a
NOTE: (1) DO NOT CONNECT two separate phases of the line voltage to the
input of the CR Series LED Light Engines, the LED driver will be damaged and
not covered by warranty. (2) Install in accordance with National & Local Electric
Code(s). (3) The AC line inputs must be connected to the same phase of the line
voltage. (4) If step dimming isn’t required, combine BLACK– Switched HOT #1
(S1) and BLACK– Switched HOT #2 (S2) together.
2
1
3
Battery Pack
HOOK ON TO END CAP
RUN WIRE HARNESS
DOWN TO PCB
ALONG SIDE
Battery Pack
Luminaire
TOP VIEW
Battery Pack
STEP DIMMING
0-10V DIMMING