THE EDGE
®
XPS Transportation Series
Catenary Mount
1 of 2
CI367X02R1_B
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
TO INSTALL:
CABLE MOUNTING
STEP 1:
Luminaire is supplied with adjustable brackets to
accommodate cables of various diameters. For cables 8
mm – 12.7 mm, keep the Reduction Brackets in place. For
cables 12.7 mm – 25.4 mm remove the reduction brackets.
See
Figure 1.
STEP 2:
After the bracket is adjusted accordingly, hang the
luminaire on the cable and tighten the (2) retained cable
bracket bolts. See
Figure 2.
STEP 3:
Tighten the bolts on outer perimeter shown in
figure 3
to
180 in/lbs.
ADJUSTING LUMINAIRE POSITION
NOTE:
The luminaire leaves the factory in a position based
on a rigid cable in perfect horizontal position running on
transversal plane to the lamp axis.
STEP 1:
Based on the vertical tilt and the horizontal orientation
of cable, the luminaire can be adjusted to ensure proper
illumination. This can be done by loosening the adjustment
bolts and moving the luminaire into the desired position.
See
Figure 3.
STEP 2:
Re-tighten the loosened bolts.
STEP 3:
Tighten the bolts on outer perimeter shown in
figure 3
to
180 in/lbs.
STEP 4:
After the luminaire is installed and positioned correctly,
make wiring connections per the
Electrical Connections
section.
Reduction Bracket for
Cable Diameters from
5/16” to 1/2”
Remove Reduction Bracket
for Cable Diameters from
1/2” to 1”
1
Tighten Bolts
to Secure Cable
Brackets
Cable
Adjustment Bolts
2
3
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before installation.
DANGER
– Risque de choc – Couper l’alimentation avant l’installation.
2. This luminaire must be installed in accordance with the NEC or your local
electrical code. If you are not familiar with these codes and requirements,
consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique
local. Si vous n’êtes pas familier avec ces codes et ces exigences, veuillez
contacter un électricien qualifié.
3. Damage to luminaire will result when improper voltage is applied. Verify
luminaire is suitable for supply voltage by checking electrical label on luminaire.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE
NOTE:
Before installing, ensure the mounting surface,
cable and the cable securement points are structurally
sound and capable of supporting the weight of the
luminaire
Bolts on Outer
Perimeter
