www.cls-led.com
CLS manuals
CLS Zense
- 11 -
- 12 -
2007 CLS-LED BV. All rights reserved. Information is subject to change without notice. CLS-LED BV and all affiliated companies disclaim liability
for injury, damage direct or indirect loss, consequential or economic loss or any other loss occasioned by the use of, inability to use or reliance
on the information contained in this manual. No part of this manual may be reproduced, in any form or by any means, without permission in
writing from CLS-LED BV. Other legal information can be found in our General conditions to be found on the back of your CLS-LED BV invoice
or on our website www.cls-led.com/conditions.pdf
Multiple connection
Possiblities on a fixture
Installation depth
In centimeters
Swivel
Fixture is horizontally rotatable,
indicated in degrees
Swivel
Fixture is vertically rotatable,
indicated in degrees
Mounting hole
In centimeters
Application area
Indoor or outdoor
Application area
Floor, wall or ceiling
Protection class
One, two or three
350º
350°
Cable length
Maximum cable attached
on the fixture in centimeters
Lifespan
Of the light source in hours
Driver
Inclusive or exclusive
Pressure
Maximum pressure on
the fixture per kg/cm
2
Weight
In gram/kilogram
Curve
Minimal bending curve
in centimeters
Driver
Incl.
10.000 h
Driver
Excl.
200 cm
6 cm
LED pitch
Pitch between the
LEDs in millimeters
20 mm
15kg/cm
2
4x4 cm
4 cm
4 cm
4 cm
4 cm
List of symbols
TEChNICAL SPECIFICATIONS
Input voltage:
12 - 24 VDC
Power consumption:
max. 2 Watt
Direct drive current:
max. 4 A
Housing:
ABS and Polycarbonate
IP value:
IP20
Measurements:
82 x 82 x 30 mm (hxwxd)
Weight:
105 gr
Operating ambient temperature:
-10 ºC till +40 ºC
MEASUREMENTS
82 mm
82 mm
30 mm
PIN
COLOUR
FUNCTION
1
Orange/white
Not connected
2
Orange
Not connected
3
Green/White
Not connected
4
Blue
DMX data -
5
Blue/White
DMX data +
6
Green
Not connected
7
Brown/White
PWR +
8
Brown
PWR - (DMX com)
PINNING DMX OUTPUT
3 x
A
B
Speed control
Touching the saturation button will set the Zense to speed control,
if the Zense is in program mode. Indication LED I3 is on. LED I4 is
also on, indicating that the Zense is in program mode. The slider
can now be used to adjust the speed of the programs.
The LEDs L1-L10 indicate the selected speed on a scale from 1 hour
to 10 seconds.
Full white
Holding the colour button for ± 3 seconds will set the saturation
and brightness to 100%. This will set all lights to maximum light
output. This feature can be used when there is a need for high light
output. When button colour or program is touched the Zense will
return to the old setting.
