Crane Merchandising Systems COTI, Техническое руководство

Страница: 20 / 140

11 COTI / ICON
Se
cti
o
n
2
-
In
sta
lla
ti
o
n
Note: If you are using paper cups, first inspect each
sleeve for damage to the cup rims. Damaged cups
must not be used.
4. The cup turret mechanism will index the first
available cups to the dispense position and drop the
cup stack into the cup drop mechanism. Fill the
remaining empty cup stack with cups and replace the
lid.
5. All Models: The water inlet valve will open and the
heater tank will start to fill. As the water heats,
ensure that no water overflows from the heater tank
overflow pipe into the waste bucket. Check the
system for leaks.
6. Instant & Freshbrew Machines : As heater tank fills
and heats, ensure that no water overflows from
overflow pipe into the waste tray.
7. Espresso Models: The machine will pump
approximately 400ml of water through the system
which will be heated to operating temperature.
Note: The machine has a safety cut - out which will
only allow the heater tank to fill for a maximum of
two minutes. If after software power
- up the heater
tank has not filled within this time, the mains power
supply should be switched off and then on again to
reset the heater tank time
- out.
Important: Should the machine fail to fill correctly or
leak, turn off the stopcock and the power to the
machine before investigating the fault.