LEDs on front
and rear
LCD
screen
Keypad
Vibrating
handle
DIN Adaptor
(Depress pin on
adaptor to locate -
Press button on
wrench to release)
Keypad Detail
Up
Escape/ Cancel
(Red)
Left
LEDs
Right
Display
Down
Enter
(Green)
Crane Electronics Ltd
The force in torque management
IQWrench2
Opta
Quick Start Guide
Man 1181-019
Crane Electronics Ltd
The force in torque management
Crane Electronics Inc
1260 11
th
Street West
Milan
Illinois 61264
USA
+1 309-787-1263
+1 309-787-2099
[email protected]
www.crane-electronics.com
Crane Electronics Ltd
Watling Drive
Sketchley Meadows
Hinckley LE10 3EY
United Kingdom
+44 (0)1455 25 14 88
+44 (0)1455 61 47 17
www.crane-electronics.com
Getting to know your IQWrench2 Opta
The Wrench
Backlight
If the backlight goes off, pressing any key will turn the wrench
back on. The backlight will not turn on when the wrench is low
on power.
Performing a Job
Select
Jobs
in main menu.
NOTe:
Jobs would have been
loaded prior to this from a PC using OptaComms or OMS.
Select user name by scrolling through list with (up/down)
arrow key and pressing
enter
key.
Enter Password by using up/down arrow key to select character
and right arrow key to go to next character. Press
enter.
Now in Job Menu. Select Job using up/down arrow key.
Press
enter
In Job measurement screen. See picture.
As the fastener is tightened, the torque value will increase.
The lights will show:
amber when torque is lOW
green when torque is OK
Red when torque is HIgH
If the buzzer is set to targeting mode, the frequency of the
buzzer will increase as the target torque is approaching until
it becomes continuous. If the vibrator is enabled, the handle
will vibrate when torque becomes OK. When the target is reached,
stop pulling and the wrench will prepare for the next fastening.
At the bottom of the screen, the reading number for that job will be displayed.
WaRNINgS
Do
NOT
pull more torque than is stated as the span figure. The wrench is a precision instrument and should
be treated with care.
4
Flange
Hydraulic Pipe
left Bracket
lock Out
Need to print label before
selecting another job
Job Menu Screen
Complete
Pressing displays description
Direction of pull
Peak mode
Torque
13.35
FlaNge
Nm
Job Name
URGENT
battery
warning
5 readings
complete out
of a total of 10
(DONE when
complete)
Job Measurement Screen
05/10
i
QuickStart Guide IQWrench2 (A5) MAY:Layout 1 11/06/2015 14:04 Page 1
