Note:
Please take care to mute your ADAT connections on your audio interface
before configuring 500ADAT’s clock source as sync noises can be present on
the ADAT outputs when the recovery clock is reconfiguring and resyncing.
This process takes approximately 3-5 seconds.
If the Sample Rate selected on 500ADAT’s DIP switches does not match the
Sample Rate of the connected audio interface, 500ADAT’s ADAT outputs are
automatically muted until the Sample Rate is matched between 500ADAT
and the connected audio interface.
Configuring Sample Rate
The Clock Settings DIP switches are also used to assign 500ADAT’s operating Sample Rate. DIP
switches 1-4 can be configured in up to 6 ways to achieve the major Sample Rates from
44.1kHz to 192kHz. The Sample Rate selected on the Clock Settings DIP switches needs to
match the Sample Rate selected on the connected audio interface to prevent clocking errors,
dropouts, and audio artefacts.
Sample Rate
DIP switch
44.1kHz
48kHz
88.2kHz
96kHz
176.4kHz
192kHz
Note:
500ADAT’s Sample Rate DIP switches must be set to match the sample rate
currently assigned on the connected audio interface. A Sample Rate
mismatch between 500ADAT and the connected audio interface could cause
issues with synchronisation and audio artefacts.
500ADAT User Manual
-Page 24-
©201
9
Cranborne Audio Ltd
