Feature Overview
500 Series Rack
The centrepiece of 500ADAT is it’s 8-slot, high-current 500 series rack. Each slot features an
abundance of I/O located on the rear panel that allows analogue input, insert, and output
connectivity per-slot much like a standard standalone 500 series rack.
Each 500 series slot is tightly integrated with 500ADAT’s converters and ADAT interface for
recording each inserted 500 series module as well as playing back ADAT sources through each
500 series module. Each 500 series slot features front-panel switches that determine its input
source and enable deeper integration with 500ADAT’s Summing Mixer and ADAT Audio
Interface.
Module Inputs
Each 500 series slot features a dedicated balanced XLR
input that is used to connect analogue signals into each
500 series module. The module input XLR can accept
mic, line, or hi-z sources depending on what module is
inserted and it’s input sensitivity options.
Note:
In instances where the 500 series module
features it’s own XLR/Jack input on the front
panel, it is advised to check with the
manufacturer of the module to determine
which input should be used for your desired
application.
Inserts
Each 500 series slot features a dedicated Insert connection that utilises a TRS jack socket in a
similar configuration that is commonly found on mixing consoles. This Insert point allows
external audio equipment such as 19” rackmount compressors and EQs to be inserted into the
audio path and recorded. The Insert is situated after the 500 series slot but before the ADC and
ADAT output path in the signal which means that the effect Inserted will be heard on the
ADAT output, Module Direct Outputs, and internal Summing Mixer.
Insert Wiring
Tip= Send, Ring= Return, Sleeve= Ground
To connect external audio equipment into 500ADAT via its Insert, you will need to use a
standard Y-split or insert cable that splits a TRS jack into 2 separate connections - a send and
return - to two mono ¼ jacks or male/female XLRs.
The ‘Send’ connector (Tip + Sleeve) should be connected to the input of your outboard
equipment and the ‘Return’ connector (Ring + Sleeve) should be connected to the output of
your outboard equipment.
500ADAT User Manual
-Page 14-
©201
9
Cranborne Audio Ltd
