Craftsman c950-52913-0, Руководство пользователя

Страница: 14 / 120

14
ASSEMBLY
SNOW CHUTE ASSEMBLY
Assemble Chute Deflector:
NOTE: The chute ring assembly (A, Figure 11) comes installed
on the unit from the factory.
1. Turn crank assembly (Figure 15) until the arrow on outer ring (B B, Fig-
ure 11) of chute ring assembly points forward.
NOTE: Make sure the slot in the chute ring aligns with the arrow
on the outer ring.
2. Install chute deflector (C C) using four screws (D D) and nuts (EE) in holes
as shown. The chute deflector must point forward for proper installa-
tion.
3. Tighten screws snugly but be careful not to over-tighten.
Assemble Remote Deflector Cable:
1. Attach rod (A A, Figure 12) to deflector post.
2. Slide compression spring (B B) over rod and insert into hole on chute
deflector bracket.
3. Attach remote deflector cable (C C) to deflector post. Secure with push
nut (D D).
NOTE: Before completing Step 4, make sure that the chute de-
flector is in the full open position.
4. Route remote deflector cable (C C) through slot in chute deflector
bracket. Secure with nuts (EE) and washers (FF) on either side of bracket.
5. Check remote deflector chute for proper operation. Make adjustments
as necessary.
Assembling the Chute Deflector Figure 11
D
A
C
Assembling the Remote Deflector Cable Figure 12
C
D
E
B
E
A
B
F
INSTALL THE DRIFT CUTTERS
Drift cutters are used to cut a path through snow deeper than the auger
housing.
1. On each side of the auger housing, insert carriage bolt (A
A, Figure 13)
through upper hole.
2. Insert lower tab of drift cutter (B B) into lower hole.
3. Secure with wing nuts (C C).
Installing the Drift Cutters Figure 13
A
C
B
Not
for
Reproduction