Craftsman 247.883971, Руководство оператора

Страница: 9 / 62

9
ASSEMBLY
Adding Fuel
WARNING
Use extreme care when handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never fuel the machine indoors or
while the engine is hot or running. Extinguish cigarettes, cigars, pipes and
other sources of ignition.
WARNING
Always keep hands and feet clear of equipment moving parts. Do not use a
pressurized starting fluid. Vapors are flammable.
1. Clean around fuel fill before removing cap to fuel.
2. A fuel level indicator is located in the fuel tank. Fill tank until fuel reaches the
fuel level indictor, Figure 10. Be careful not to overfill.
Fuel Level Indicator
Top View
Figure 10
Checking Oil Level
The engine is shipped with oil in the engine. You must, however, check
the oil level prior to operating the snow thrower. Running the engine
with insufficient oil can cause serious engine damage and void the engine
warranty.
CAUTION
NOTE: Be sure to check the engine on a level surface with the engine stopped.
To avoid engine damage, it is important to:
•
Check oil level before each use and every 5 operating hours when engine is
warm. Check oil level more frequently during engine break-in.
• Keep oil level between “H” and “L” marks on dipstick. See Figure 11.
• Be sure oil fill cap/plug is tightened securely when checking.
1. Remove the oil filler cap/dipstick and wipe the dipstick clean. See Figure 11.
2. Insert the cap/dipstick into the oil filler neck, and tighten the cap turning
clockwise until cap is seated.
Drift Cutters
The snow thrower drift cutters are mounted inverted at the factory for shipping
purposes.
1.
Remove the four wing knobs (two on each side) and carriage bolts. Place
drift cutter in upright position and re-secure. See Figure 9.
Figure 9
Tire Pressure (Pneumatic Tires)
WARNING
Under any circumstance do not exceed manufacturer’s recommended psi.
Equal tire pressure should be maintained at all times. Excessive pressure
when seating beads may cause tire/rim assembly to burst with force
sufficient to cause serious injury. Refer to sidewall of tire for recommended
pressure.
The tires can be over-inflated for shipping purposes. Check the tire pressure
before operating the snow thrower. Refer to the tire side wall for manufactures’s
recommended psi and deflate (or inflate) the tires as necessary.
NOTE: Equal tire pressure is to be maintained at all times for performance purposes.
Fuel Recommendations
Use automotive gasoline (unleaded or low leaded to minimize combustion chamber
deposits) with a minimum of 87 octane. Gasoline with up to 10% ethanol or 15%
MTBE (Methyl Tertiary Butyl Ether) can be used. Never use an oil/gasoline mixture
or dirty gasoline. Avoid getting dirt, dust, or water in the fuel tank. DO NOT use E85
gasoline.
•
Refuel in a well-ventilated area with the engine stopped. Do not smoke or
allow flames or sparks in the area where the engine is refueled or where
gasoline is stored.
• Do not overfill the fuel tank. After refueling, make sure the tank cap is closed
properly and securely.
• Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may
ignite. If any fuel is spilled, make sure the area is dry before starting the
engine.
• Avoid repeated or prolonged contact with skin or breathing of vapor.