page 8
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then
tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
*Remember that antenna for remote control
receiver must rest
outside
of hanging bracket.
canopy cover
screw
canopy
hanging bracket
screw
antenna
8. Final Installation.
If you wish to use the light kit,
align grooves
on shade with nodules on
inside
of LED light
kit and push up gently on shade. Twist shade
to the RIGHT (clockwise) until glass shade
locks into place.
Pull down VERY GENTLY on shade to make sure
that shade is secure.
If you do NOT wish to use the light kit
,
locate
slots on metal cover and align with nodules
inside
LED light kit
. Gently push up on metal
cover and turn to the
RIGHT (clockwise)
until
it no longer turns.
WARNING
: Metal cover will be HOT if light
button on remote/wall control is used. To
reduce the risk of personal injury, do NOT use
light buttons on remote or wall control if
installing metal cover.
grooves
nodules
shade
(or metal
cover)
LED
light kit
