Craftex CX118, Руководство пользователя, Страница: 11 / 26

11
tracking knob at the back of the band saw
shown in figure-9.
TO CHECK AND ADJUST THE BLADE
TRACKING:
Disconnect the machine from the power
source and open the upper wheel cover.
Rotate the upper wheel by hand slowly and
observe how the blade rides on the wheel
through the window shown in figure-10.
Figure-9 Upper wheel
Blade should track in the center of the
wheel.
If the blade does not track in the center and
needs to be adjusted, loosen the lock
thumb screw shown in figure-18 and turn
the tracking knob.
Figure-10 Blade tracking controls
Loosen lock thumb screw and turn the
tracking knob, while rotating the wheel by
hand.
TIGHTEN THE TRACKING KNOB:
If the blade moves towards the front edge
of the wheel. It makes the top of the wheel
to tilt back and moves the blade towards
the center.
LOOSEN THE TRACKING KNOB:
If the blade moves towards the back edge
of the wheel. It makes the top of the wheel
to tilt to the front and moves the blade
towards the center.
When the blade consistently rides in the
center of the wheel after several rotations,
retighten the lock thumb screw and close
the wheel cover.
ON/OFF SWITCH
The ON/FF switch on the CX118 comes
with a removable key which disables the
switch and prevents from unauthorized
operation.
Simply remove the key and the band saw
will not start. Insert the key back into the
switch and it enables the switch.
There is a small switch above the band saw
ON/OFF switch which turns the LED work
lamp on and off. See figure-11.
Figure-11 Switch