Craftex CX118, Руководство пользователя, Страница: 10 / 26

10
INSTALLING THE
EXTENSION WING
Remove the stop screw and washer from
the end of each extension rod. Attach the
extension rods to the extension wing using
screws and washers provided. See figure-5.
Figure-5 Attaching the rods to the extension
wing
Slide the rods with the extension wing into
the brackets under the table and secure it
by tightening the lock knobs. See figure-6.
Thread the stop screws and washers back.
Figure-6 Attaching extension wing to the
table
INSTALLING FENCE
Attach the guide rail to the front of the table
as shown in figure-7. Secure it using flat
washers and lock knobs provided.
Figure-7 Installing the fence rail
Place the fence assembly on the fence rail
and table. The rear hook should engage the
rear of the table.
Figure-8 Installing the fence on the rail
Lock the fence handle, securing it to the
guide rail and verify that fence is still
parallel to miter slot.
BLADE TRACKING
ADJUSTMENT
The blade tracking refers to where blade
rides on the upper and lower wheels. The
blade should always be centered on both
wheels.
Although the blade tracking of this band
saw is factory set. However we recommend
you to check it again to make sure that the
blade is centered on the wheels. The blade
tracking can be controlled by adjusting the