Crafco SUPER SHOT 125, Инструкция по эксплуатации и запасным частям

Страница: 52 / 230

Super Shot 125 Diesel Melter Part Manual
Chapter 6 Maintenance Instructions
©2017 by Crafco, Inc. All Rights Reserved………………..………………………………..….…Maintenance Instructions 6-4
6.12 Maintenance Chart
For a list of parts required for maintenance see
Table 6-3 General Maintenance Parts .
Table 6-1 Maintenance Chart
Hours
Possible Cause Procedure 8 50 250 500
Engine Check Oil Level
Refer to the manufacturer’s
instructions for the engine
X
Other Engine Maintenance
Refer to the manufacture’s
operating and maintenance
instructions for the engine
Material Sensor Tube
Check for HTO fluid X
Add As needed
Heat Transfer Oil
Check X
Change X
Hydraulic Oil
Check X
Change X
Hydraulic Oil Filter Change X
Burner
Check burner box insulation X
Clean CAD cell X
Check Electrodes X
Burner Flame Retainer X
Replace burner nozzle X
Wheel Bearings
Clean and re-pack using a good
grade of bearing grease Every 24,000 miles
(38,624 km) or two years
Tongue Jack
Grease using a good grade of
bearing grease
Once a year
Air Compressor Oil
Check
X
Change Once a year
Material Tank
Scrape out built up material in
the material tank
Once a year or as needed
Material Sensor Guard
Scrape out built up material
around guard
X