Crafco SUPER SHOT 125, Инструкция по эксплуатации и запасным частям

Страница: 120 / 230

Super Shot 125 Diesel Melter Part Manual
Chapter 9 Troubleshooting (47400)
©2017 by Crafco, Inc. All Rights Reserved………………...…………………………………Troubleshooting (47400) 9-16
Step Possible Cause If . . .
7 Is there 12Vdc between top terminal of the
burner reset toggle switch orange wire and a
nearby ground (black wire)?
•
Yes, check for loose connections or broken
wires between toggle switch and hot oil
PAKSTAT terminal #3.
•
No, go to step 7a.
7a Is there 12Vdc between bottom terminal wire
labeled RED-3 and a nearby ground source
(black wire)?
•
Yes, replace toggle switch.
•
No, go to step 8.
8 Is there 12Vdc between the top terminal of
circuit breaker red wire labeled RED-3 and
nearby ground source (black wire)?
•
Yes, check for loose connections or broken
wires between circuit breaker and toggle
switch.
•
No, go to step 9.
9 Is there 12Vdc between bottom terminal
(orange wire) of burner ON/OFF toggle
switch and nearby ground source (black
wire)?
•
Yes, check for loose or broken wires
between top terminal power switch and
terminal #3 of the hot oil PAKSTAT.
•
No, go to Step 10.
10 Is there 12Vdc between middle terminal (red
wire) of burner ON/OFF toggle switch and
nearby ground source (black wire)?
•
Yes, replace switch.
•
No, go to Step 11.
11 Is there 12Vdc between the “Main Power
Switch” (red-2 wire) and nearby ground
source (black wire)?
•
Yes, check for loose or broken wires
between those two points.
•
No, go to Step 12.
12 Is there 12Vdc between the “Main Power
Switch” (red-3 wire) and nearby ground
source (black wire)?
•
Yes, replace contact block.
•
No, go to Step 13.
13 Is there 12Vdc between top terminal of circuit
breaker (red wire) and nearby ground source
(black wire)?
•
Yes, check for loose or broken wires
between top terminal of circuit breaker and
bottom terminal (red wire) of power switch.
•
No, go to Step 14.
14 Is there 12Vdc between bottom terminal of
circuit breaker (red wire) and nearby ground
source (black wire)?
•
Yes, replace circuit breaker.
•
No, go to Step 15.
15 Check connections and condition of red
battery cable.
•
Yes, there should be 12Vdc at all previous
steps.
•
No, replace battery cable.
Table 9-17 Mixer Electrical Troubleshooting (continued)