Crafco SS60-Diesel, Руководство пользователя

Страница: 56 / 119

Super Shot 60 Diesel Melter Part Manual
Chapter 8 Troubleshooting
©2016 by Crafco, Inc. All Rights Reserved
………………...………………………………..……………...Troubleshooting 8-8
8.0.4. Testing the DC Controller
Step Bench Test DC Controller
1 Remove all wire nuts attaching the DC Controller to the burner.
2
Attach the black ground wire to the negative battery post.
3
Attach the red wire to the positive battery post.
4 Attach the white (Enable) wire to the positive battery post to start the test. (Genesis II
Controllers will have a 15-second delay.)

Orange (Blower Motor) wire should have 12Vdc (all the time).

Blue (Igniter) wire should have 12Vdc.
• Purple (Fuel Solenoid) wire should have 12Vdc (after the delay).
5 Twist the yellow wires together (once voltage registers) on the orange, blue and purple wires.

Orange (Blower Motor) wire should maintain 12Vdc.

Blue (Igniter) wire should lose voltage after 15 seconds.

Purple (Valve) wire should maintain 12Vdc.
• Purple (Fuel Solenoid) wire should maintain 12Vdc.
6 If any of the above tests fail, replace the DC Controller.
8.0.5. Burner Fuel Solenoid Testing
Step Fuel Solenoid Test
1 Remove cord set from fuel solenoid.
2 Check the ohms between the terminals of fuel solenoid.
3 If the reading is between 15-25 ohms the coil is good.
4 If the reading is outside the above range or the meter indicates an open circuit, replace the
fuel solenoid.
Table 8-9 Testing the DC Controller
Table 8-10 Burner Fuel Solenoid Testing