CR Remeha Quinta Pro 115, Инструкция по установке и обслуживанию

Страница: 27 / 92

n
Connection in areas of different pressure (C53, C83)
Combustion air supply and combustion gas discharge are possible in
various pressure zones, semi-CLV systems. With the exception of
coastal areas. The maximum permissible difference in height
between the combustion air supply and the combustion gas discharge
is 36 m.
Chimney length in the various pressure zones
Diameter
Maximum length (
L
)
Quinta Pro
30 45 65 90 115
80 mm 20 m 20 m - - -
90 mm 36 m 36 m 2 m - -
100 mm 36 m 36 m 8 m 4 m -
110 mm 36 m 36 m 34 m 32 m 24 m
130 mm 36 m 36 m 36 m 36 m 36 m
n
Reduction table
Pipe reductions per element used
Diameter
Elbow 45° Elbow 90°
Pipe reduction Pipe reduction
80 -125 mm 1 m 2 m
100 -150 mm 1 m 2 m
80 mm 1.2 m 4.0 m
90 mm 1.3 m 4.5 m
100 mm 1.4 m 4.9 m
110 mm 1.5 m 5.4 m
130 mm 1.6 m 6.2 m
4.7.4. Additional Directives
4
Please refer to the manufacturer’s instructions for the material in
question when installing the flue gas discharge and air supply
materials. If the flue gas discharge and air supply materials are not
installed according to the instructions (e.g. they are not leakproof,
not clamped in place etc.), this may cause hazardous situations
and/or result in bodily injury. After assembly, check at least all flue
gas and air–carrying parts for tightness.
4
Connection of the combustion gas exhaust directly to the buildings
brick chimneys or flues is forbidden for condensation reasons.
4
Always clean the ducts thoroughly in cases where lining pipes are
used and/or a connection of the air-supply.
4
It must be possible to inspect the flue or chimney.
4
In cases where condensate coming from the stainless steel or
plastic sections of the flue gas pipe can be driven back towards
the aluminium section, this condensate must be removed using a
collecting device before the aluminium section is reached.
T000780-C
L
Quinta Pro 30 - 45 - 65 - 90 - 115 4. Installation
250413 - 123157-03 25