CR Remeha Quinta Pro 115, Инструкция по установке и обслуживанию

Страница: 25 / 92

Type Execution Description
C33 Closed
4
Exhaust of combustion gases above the roof.
4
The opening for the air-supply inlet is located in the same pressure zone as the vent (For
example, a concentric passage to the roof).
C43
(2) Closed/Cascade
4
Common channelling for the air-supply and exhaust of combustion gases (CLV):
- Concentric.
-
Eccentric; Air supply from the shaft.
4
This also relates to the overpressure cascades.
C53 Closed
4
Closed equipment.
4
Separate channelling for the air-supply.
4
Separate channelling for the combustion gases.
4
Terminating on different pressure surfaces.
C63 Closed
4
The manufacturer delivers this type of equipment without a supply or exhaust system.
C83
(3) Closed
4
The equipment can be connected on a so-called semi-CLV system (with common combustion
gas exhaust).
C93
(4)
Closed
4
Channel for the air-supply and exhaust fumes in a duct or surrounded by a sleeve:
-
Concentric.
- Eccentric; Air supply from the shaft.
-
Exhaust of combustion gases above the roof.
-
The opening for the air-supply inlet is located in the same pressure zone as the vent.
(1) Including the pressure classification P1
(2) EN483: 0,5 mbar suction by pressure reduction
(3) An under pressure of 4 mbar is possible
(4) See table for minimum sizes of duct or sleeving
Type Execution Diameter Minimum size of the duct or jacket
Without air-supply
With air-supply
∅
Channel
⃞
Channel
∅
Channel
⃞
Channel
C93 Rigid 60 mm 110 mm 110 x 110 mm 120 mm 110 x 110 mm
80 mm 130 mm 130 x 130 mm 140 mm 130 x 130 mm
100 mm 160 mm 160 x 160 mm 170 mm 160 x 160 mm
Flexible 60 mm 110 mm 110 x 110 mm 120 mm 110 x 110 mm
80 mm 130 mm 130 x 130 mm 145 mm 130 x 130 mm
100 mm 160 mm 160 x 160 mm 170 mm 160 x 160 mm
Concentric 60/100 mm 120 mm 120 x 120 mm 120 mm 120 x 120 mm
80/125 mm 145 mm 145 x 145 mm 145 mm 145 x 145 mm
100/150 mm 170 mm 170 x 170 mm 170 mm 170 x 170 mm
4.7.2. Outlets
For exhausting combustion gases of types C1, C3 and C5, it is
appropriate to use a
M&G Skyline / Mugro 3000
or a
Coxstand E
HR
. When exhausting combustion gases of type C6, the material of
the exhaust must conform with Gastec QA and/or be provided with
CE marking.
The exhaust vent for combustion gases must conform to EN
1856-1. The flue gas pipes must be calculated conforming to EN
13384 (parts 1 & 2).
For open exhaust of combustion gases above the roof, the
vent must always be provided with a suitable stainless steel
wire grill.
Quinta Pro 30 - 45 - 65 - 90 - 115 4. Installation
250413 - 123157-03 23