CPS SCA Series, Инструкция по установке и эксплуатации

Страница: 73 / 164

65
Table 4-2 Definition of the Keys
Key Description Definition of function
Escape key Back/end/mute
Enter key
Confirm entering the menu/confirm set
value/Switch to parameter setting mode
Up
Page up in selection menu/+1 when setting
parameters
Press more than 1 second to go to the last
number when setting the parameters. eg:
from 2008 to 2020
Down
Page down in selection menu/-1 when
setting parameters
Press more than 1 second to go to the next
number when setting the parameters. eg:
from 2008 to 2020
4.2 Operation State
“POWER”
LED indicates that the system is energized and under DSP control
when “POWER” lights up.
“RUN”
LED will illuminate when the inverter detects that the grid connection
conditions meet the requirements and power is being fed into the grid. The
“RUN” LED will blink if the grid is in a de-rated running state while feeding
power into the grid. Derate may be caused by low grid voltage; mppt voltage
out of range; or excessive temperature.
“GRID”
LED will illuminate when the grid is normal during inverter operation.
Otherwise, the “GRID” LED will continue to blink until the grid restores to
normal.
“FAULT”
LED will blink quickly as a fault (except grid fault) occurs. The
“FAULT” LED will stay illuminated until the fault is eliminated. The LED will
blink slowly when an alarm occurs. The “FAULT” LED remains illuminated
when an internal fault occurs.