Thermostatic
Griddles
Cooking Performance Group
.
www.cookingperformancegroup.com
Gas Conversion Guide
Follow the below steps to convert your CPG Thermostatic Griddle from Natural Gas to Liquid Propane.
These units are shipped fully equipped for use with Natural Gas. If you want to convert your unit to LP,
a different orifice is necessary. Orifice(s) for Liquid Propane are provided in a bag tied to the valve on
the front panel of the unit. The following steps will explain how to replace the burner orifice(s), pilot
orifice(s), and how to set the gas regulator to your new gas type.
Safety Precautions
CAUTION:
• Failure to comply with the following operation instructions could lead to potential hazards and/or
unsafe practice and could result in injury and damage to product and property.
NOTICE:
• Local codes regarding installation vary greatly from one area to another. The National Fire
Protection Association, Inc., states in its NFPA96 latest edition that Local codes are “Authority
Having Jurisdiction” when it comes to requirement for installation of equipment. Therefore,
installation should comply with all Local codes.
• This product is intended for commercial use only. Use in residential setting will void the warranty.
WARNING:
• Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
other equipment.
• Improper installation, adjustment, alteration, service or maintenance could lead to property
damage, injury or death. Read the installation, operating and maintenance instructions thoroughly
before installing or servicing CPG equipment. This manual must be retained for future reference.
• A licensed installer must handle all maintenance and repair.
Gas Pressure
• The appliance and its individual shutoff valve (to be supplied by user) must be disconnected from
the gas supply piping system during any pressure testing of that system at test pressures in excess
of 1/2 PSI (3.45 kPa).
• The appliance must be isolated from the gas supply piping system by closing its individual manual
shut-off valve during any pressure testing of the gas supply piping system at test pressures equal
to or less than 1/2 PSI (3.45 kPa).
