Specifications
Operator's Manual
A-3
A.2.5
Alarm Conditions
Note:
During multiple-alarm conditions, alarms are presented as follows:
•
If two medium-priority alarms occur simultaneously, the alarm status message toggles between the
two.
•
If a medium-priority and low-priority alarm occur simultaneously, only the medium-priority alarm is
displayed and only the medium-priority tone is sounded.
•
A medium-priority physiological alarm overrides a low-priority alarm.
Table A-5.
Alarm Conditions
Priority
Rate
Color
Type
Messages
Medium
Sounds every 8 seconds
while the alarm condi-
tion persists
Yellow
Steady message, slow
flashing label
Physiological
High rSO
2
Low rSO
2
Technical
Sensor not connected
Excessive light
Poor signal quality
Preamp not connected
Replace sensor
Interference detected
Sensor unusable
Low
Sounds every 16 seconds
while the alarm condi-
tion persists
Steady yellow
Technical
Battery low
COM port unavailable
Printer unavailable
USB storage full
USB storage error
Auto baseline set
Содержание INVOS 5100C
