ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
TGS64DP
-WM
PAGE 1 OF 2
COURTYARD CREATIONS INC.
PARTS LIST
PART
NO.
MATERIAL CODE
PART
Q’TY
PART
NO.
MATERIAL CODE
PART
Q’TY
1
1
2
3
4
5
7
6
8
9
10
4
2
4
12
12
1
8
1
6
TGS64DP-CS05-1
TGS64DP-CS04-1
TGS64DP-CS04-2
62TGS65DPY101
17C17A0403001Y4
17C01A0706002Y4
17C01A0709002Y4
17FA05040301-Y4
18000337002
17KAA0201----Y4
TABLE TOP
LEG
SUPPORT
CENTER
CONNECTOR WITH RING
SCREW ST4.2*12
BOLT M6*16
BOLT M6*25
WASHER d6.5*D13*1.0
BOLT CAP M6
HEX.KEY WRENCH 6MM
FIGURE 1
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #10)
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Insert the legs (#2) and supports (#3) into the plastic
holders on the table top (#1) rim. Fasten them together
by using screws (#5). See Figure 1.
Attention:
Make sure that each bolt needed for all steps matches
the corresponding figure to ensure proper assembly.
1
2
2
2
2
3
3
STOP DON’T RETURN TO STORE!
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
5
Use the correct bolts as indicated. Do not tighten any of the bolts until is completely assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
!
!
!
!
!
!
!
